SKU 110030- New
- 1 Year / 1,000 Hour Limited Warranty (Whichever comes first)
- Input: 110 Volt
- Output: 24 Volt
- Amps: 3
The model 5100 series 3 Amp and 5
Amp battery chargers are designed
for permanent connection to
automotive batteries, maintaining
them in a fully charged condition
without overcharging. The chargers
are also capable of rapidly
recharging the batteries at a current
up to the full rated output. The
charger may also be used to supply
a standing load attached to the
battery. The charger output may be
factory set to account for the
standing load.
The charger is designed for
reliability, ease of installation and
accessibility during routine servicing.
It features radio frequency
suppression and its smooth output
linear mode design has a low ripple
voltage making the charger suitable
for use with electronic equipment.
The charger has both Overload and
Short Circuit protection features,
achieved by limiting the current to a
safe value during these conditions. It
will automatically recover after the
condition is removed.
If a short circuit or a severe overload
is applied such that the voltage falls
below four volts for longer than 10
seconds, then the Charge Fail
Alarm relay will energise and the
charge fail contact will close.
If the charger is inadvertently reverse
connected to the battery then the
fuse-link on the circuit board will
rupture. This should be replaced
with a 10A quick blow type.
NOTE
The ‘Charger On’ LED will
illuminate even if the fuse has
ruptured.
The electronic control circuit ensures
that the charger can remain operating
during engine cranking and running,
operating in parallel with the charge
alternator where necessary.
The charger features a boost charge
facility to enable rapid recharging of
discharged batteries or to allow
periodic equalisation of battery cells.
When the ‘boost mode select’
terminals are connected together the
charger output will rise by 0.35V per
cell.
CAUTION!
Boost mode must only be used in
accordance with the battery
manufacturers instructions
otherwise cell damage or an
increased maintenance
requirement will occur.
SPECI F ICATION
DC OUTPUT:
12 V DC or 24V DC Nominal
(specified on ordering)
AC INPUT:
220 - 250 V AC 50/60Hz
(Specified on ordering)
OUTPUT CURRENT:
3Amps or 5Amps electronically
limited
(specified on ordering).
OPERATING TEMPERATURE
RANGE:
-10 to +60oC
INDICATIONS:
‘Charger On’ LED.
PROTECTIONS:
Short Circuit, Over Voltage,
Over-current, Reverse Polarity,
Reverse Power
BOOST MODE:
+0.35V per Cell above Float
voltage.
OPERATION:
The charger will supply current
to the battery until the battery
terminal voltage is equal to the
set float voltage, at which point
only a trickle charge current is
present. When the battery
voltage falls due to a load being
applied and the battery being
discharged, the charger will
once again supply current to
restore the voltage of the battery
to the float voltage.
Specifications may vary. Confirm full specs prior to ordering.