SKU 110042- New
- 1 Year / 1,000 Hour Limited Warranty (Whichever comes first)
- Input: 120 VAC / 60 Hz
- Output: 24 VDC / 20 Amp
- Amps: 20
- Model: AE
C-CHARGER®
FERRORESONANT BATTERY CHARGERS
MODEL 'AE' - ENGINE GENERATOR SET FLOAT CHARGER
Model - 'AE' Chargers are the leading choice for efficiency and simplicity.
Stainless steel for corrosion resistance
Ferroresonant transformer for reliability
2-year limited warranty
UL and CUL listed
DC ammeter to indicate charge rate
DC voltmeter
AC circuit breaker
Cannot discharge battery during AC failure
Float-equalize switch
Sealed silicon diodes
Safe to say, there's no other float charger built like a C-CHARGER® - Model 'AE'. Rugged #304 stainless steel forms the tough housing that withstands virtually any environmental effects.
Electrically, the C-CHARGER® uses a ferroresonant transformer which by its nature, is self-regulating and completely devoid of any complicated switching circuits that could possibly burn out. There are no tubes nor delicate electronics to fail or to cause radio frequency interference (RFI).
Voltage output to the batteries remains at a safe and constant DC level from full load to no load even if the AC power runs as high as 132 VAC or as low as 108 VAC. All components are designed to operate safely and continuously in an ambient temperature as high as 122° F.
SPECIFICATIONS FOR MODEL - 'AE' FERRORESONANT BATTERY CHARGERS
Standard Accessories Optional Accessories
DC ammeter
DC voltmeter
Equalize light
Float-equalize switch
AC circuit breaker
Terminal board
0-24 Hour equalize timer
Automatic 24 hour equalize timer
Low DC voltage alarm relay
High DC voltage alarm relay
Current failure relay
AC power failure relay
DC cranking disconnect relay
AC pilot light
Drip shield
Specifications Environmental
AC input
108-132 volts 60 Hz
(220 Volts 50 Hz optional)
Operating Temperature 0 to 50ºC (122ºF)
Storage Temperature: -20º to 60ºC
Cooling: Convection
DC Output Enclosure
Float: 2.16 VPC for lead acid
(1.45 VPC nickel cadmium)
Equalize: 2.33 VPC for lead acid
(1.55 VPC nickel cadmium)
Current limit at approximately 135%
304 stainless steel hinged cover to facilitate installation
MODEL - 'AE'
AE2410*
10 Amps
24 Volts
11"
9"
8.5"
22 lbs.
AE2420*
20 Amps
24 Volts
16-3/8"
15"
8.5"
38 lbs.
* UL Listed
Specifications may vary. Confirm full specs prior to ordering.